Technical reference manual for dataTaker 50/500/600 Series 3 data loggers with firmware version 7.xx, covering construction, interfacing and programming.
This technical reference manual applies to Series 3 dataTaker 50, 500, 505, 515, 600, 605 and 615 model data loggers with firmware version 7.xx installed. It states that it can also be used in support of earlier Series 1 and Series 2 loggers, with differences checked against the original Getting Started and Concise manuals. The dataTaker is described as a microprocessor-based data acquisition instrument that can monitor, record and raise alarms for parameters such as temperature, pressure, flow, counts and events.
The manual's sections cover the dataTaker construction, powering and serial interfaces, analog and digital input channels, temperature and bridge measurements, programming commands and schedules, alarms, data logging to memory, the keypad and display module, warnings and error messages, and appendices.
| Models covered | dataTaker 50, 500, 505, 515, 600, 605 and 615 |
|---|---|
| Firmware version | 7.xx |
| Serial interface | RS232 |
It covers the Series 3 dataTaker 50, 500, 505, 515, 600, 605 and 615 model data loggers.
It applies to data loggers with firmware version 7.xx installed.
DeLogger and DeTransfer are named as companion software for supervising the dataTaker from a host computer.
It can monitor, record and raise alarms for parameters such as temperature, pressure, flow, counts and events.