Installation manual for the Cyfre CA-NEX signal amplifier, covering parts, tools, warnings, vehicle mounting, wiring, antenna requirements, and warranty.
The Cyfre CA-NEX Nextel signal amplifier installation manual covers the parts list, required tools, warnings, mounting location, and wiring steps for installing the amplifier in a vehicle. It includes cautions about drilling, power connections, fuse rating, and antenna separation.
The manual describes connecting the supplied 2 m DC power cable to a 10 to 30 V DC, fuse-protected, ignition-switched circuit and attaching a 50 ohm 800/1900 MHz dual band cellular/PCS antenna. It also states a recommended maximum antenna gain of 7dBi and a one-year limited warranty.
| Operating power range | 10 to 30 V DC |
|---|---|
| Antenna connection | 50 ohm 800/1900 MHz dual band cellular/PCS |
| Recommended maximum antenna gain | 7 dBi |
| DC power cable length | 2 m (78 in) |
| Minimum antenna separation | 20 cm (7.87 in) |
| Fuse rating | 3 amps |
Suggested locations are under the dashboard, under the seat, or in the trunk, as close to the phone handset as possible.
It should be connected to a 10 to 30 V DC, fuse-protected, ignition-switched circuit; voltages above 30 V DC can damage the amplifier.
The manual recommends an external antenna with a maximum gain of 7dBi; higher-gain antennas violate FCC regulations and void warranty claims.
The manual refers to a 3-amp fuse and says changing to a higher rating voids the warranty.