Quick start guide for the congatec conga-STDA4 (Prototype Rev. X.0) SMARC module sample distribution set: contents, hardware setup and license notes.
This quick start guide describes the contents of the Sample Distribution Set for the congatec conga-STDA4 (Prototype Rev. X.0), a SMARC module based on TI ARM processors, and explains how to set it up. The document is intended for technically qualified personnel and covers the included hardware, pinout access, the conga-SEVAL evaluation carrier board and the hardware setup steps.
It also contains congatec's notices on open source software, the disclaimer, RoHS directive, electrostatic sensitive device handling, warranty, technical support and revision history. The set includes the module, the conga-SEVAL carrier board, a passive cooling solution, a console cable, an SD card, an RS-232/USB adapter and this guide; a power supply is not included.
| Processor (conga-STDA4/i-DRA829J-4G eMMC32) | TI ARM networking processor DRA829 with 2x ARM Cortex-A72 @ 2.0GHz + 2x ARM Cortex-R5F |
|---|---|
| Memory | 4GB onboard LPDDR4x, 32GB onboard eMMC |
| Accelerator (TDA4VM variant) | 8 TOPS MMA (deep-learning matrix multiply accelerator) |
| Temperature range | Industrial grade, -40°C to 85°C |
| Mounting torque | 0.4 Nm |
| Included SD card | SDHC UHS-I 16GB (standard SD card size) |
| Included adapter | FTDI USB 2.0 to standard serial port |
No. A power supply is not included; the guide recommends using an ATX power supply.
The pinout is available as an Excel file through the given link, and you must contact congatec support to get access to it.
The guide specifies a final torque of 0.4 Nm for both the cooling solution and the module.
Enter the command "license" in the bootloader to get the complete product related license information.