Cologne Chip CCGM1A1 FPGA Toolchain Installation User Guide

Step-by-step guide for installing and using the Cologne Chip CCGM1A1 FPGA toolchain on Linux and Windows.


Cologne Chip CCGM1A1 FPGA Toolchain Installation User Guide - cover page
Brand
Cologne Chip
Document type
User Manual
Language
Chinese
Pages
18
File format
PDF
File size
2 MB
Published
17 November, 2026
Updated
17 November, 2026
MD5 checksum
2EF77C9A206443D6FA4AAFC7AB8912EC

About this manual

This user guide provides instructions for installing the Cologne Chip CCGM1A1 FPGA toolchain, covering both pre-built software downloads and compiling from source. It includes setup for Linux and Windows environments, installation of optional simulation tools like Icarus Verilog and GTKWave, and quick start steps for synthesizing, implementing, and programming FPGA designs. The guide assumes familiarity with command-line tools and is intended for users working with the GateMate™ FPGA series. This manual is written in Chinese.

What's inside

  • Toolchain Overview
  • Hard- and Software Requirements
  • Download pre-build Software
  • Build Software from Source
  • Install Optional Simulation Tools
  • Quick Start

Frequently asked questions

What operating systems are supported for the GateMate toolchain?

The toolchain supports Debian-based, Arch-based, and Red Hat-based Linux distributions, as well as Windows 7 or later 64-bit.

Where can I download pre-built toolchain packages?

Pre-built packages are available after logging into your account at https://colognechip.com/mygatemate/ and navigating to the software download section.

How do I configure the FPGA via JTAG on Linux?

Run the command `make jtag` which executes `openFPGALoader -b gatemate_evb_jtag _00.cfg.bit`.

Which USB driver must be installed for the evaluation board on Windows?

The libusb-win32 driver must be installed using Zadig.

Download PDF (2 MB)