CheckPoint Quantum Spark 1530/1550 Device R80.20.XX Getting Started Guide

About this manual

This document serves as the Getting Started Guide for the CheckPoint Quantum Spark 1530/1550 device running software version R80.20.XX. It provides step-by-step instructions for unboxing the equipment, performing physical installation (desktop or wall-mount), and connecting necessary cables including power and network interfaces.

The guide details the initial deployment options available for the device, specifically the First Configuration Wizard, ZeroTouch cloud service, and USB drive methods. It also includes a description of the device's front, rear, and side panels, explaining the function and status indicators of the various LEDs. This manual is written in Chinese.

What's inside

• Introduction
• Shipping Box Contents
• Setting Up the Device
• Wall Mount Installation
• Connecting Cables
• First Deployment Options
• Device Diagram and Specifications
• Using the First Configuration Wizard
• ZeroTouch Cloud Service
• Support

Specifications

Frequently asked questions

What is the pre-configured IP address for the LAN1 network interface?

The LAN1 interface is pre-configured with the IP address 192.168.1.1.

What baud rate should be set when using the console cable?

The baud rate must be set to 115200 with flow control set to none.

How long must you wait after restarting the device before proceeding?

You must wait 10 seconds after each restart (switch) before continuing.

What is the minimum distance required between your body and the device's heat sink?

Your body must maintain a distance of at least 20 centimeters from the heat sink.