User manual for the CF-360 bulk capacitor lead cutting machine: feeding, lead-length adjustment, waste cleaning, maintenance and troubleshooting.
The CF-360 is a lead cutting machine for standing (vertical) electronic components such as capacitors, LEDs, power transistors, resistor networks and transistors. Cutting length is adjustable from 3 mm to 20 mm for lead diameters of ψ0.35 to ψ2.0 mm, and the machine has a reserved hole position for adding a counter. The manual contains the part list, the operating procedure, and instructions for setting the C37 guide rails, the D4 hold-down mechanism and the cutting length with the E53 lifting screw and E59 scale.
It further covers waste removal through the A11 waste box, lubrication and maintenance points, replacement and alignment of the E55 stationary blade and E56 moving blade, and troubleshooting for feeding and cutting faults. A closing section explains how the CF-360 can be expanded into a fully automatic feeding and cutting setup with a bowl feeder, and lists the CF-366, CF-3661, CF-3662 and CF-368 models for different component shapes, with the company's service telephone and fax numbers. This manual is written in Chinese.
| Lead diameter range | ψ0.35 mm to ψ2.0 mm |
|---|---|
| Suitable components | Standing components such as capacitors, LEDs, power transistors, resistor networks and transistors |
| Counter mounting | Reserved hole position for fitting a counter |
| Automatic expansion | Can be extended to fully automatic feeding and cutting |
| CF-366 cylindrical component range | Outer diameter Ø4 mm to Ø8 mm |
| CF-3661 range | Electrolytic capacitors ψ4 mm to ψ8 mm, LEDs ψ5 mm |
| CF-368 range | Electrolytic capacitors ψ10 mm to ψ18 mm |
The cutting length can be adjusted freely from 3 mm to 20 mm, for lead diameters of ψ0.35 to ψ2.0 mm.
Loosen the E511 screw, then turn the E53 lifting screw so that the E5 cutter seat slides up or down; the number on the E59 scale indicates the lead length.
The E5 cutter seat may be raised so that it touches the C38 track and cancels the vibration; lower the E5 cutter seat and feeding returns to normal.
Order a special E55 stationary blade made for lengths below 3.0 mm, or have the original blade and the C38 track ground thinner at the factory.