CES VMDIS 8004 VME/VSB display and diagnostic module leaflet covering display modes, registers, counters and VME interrupt/SYSRESET features.
This leaflet presents the CES VMDIS 8004, described as a brand-new VME/VSB Display and Diagnostic Module intended to monitor backplane activity and measure the performance of modern VME/VSB systems. In VME mode it displays address lines including A64, data lines including D64, address modifier lines and control lines; in VSB mode it displays address, data and control lines. Display can be direct, latched or monitor, and control and status registers are accessible over VME through a VME Slave interface. The module also provides High-Speed Slot 1 functions, a VSB Central Arbiter, a block transfer counter and a cycle duration timer, with the delay between DS and DTACK programmable in monitoring mode. A VME interrupter and VME SYSRESET can each be activated by a front-panel push-button or an external NIM/TTL signal, and SYSRESET can also be generated in response to a software request.
The VMDIS 8004 is described as an extension of the VMDIS 8003, adding visual and computer-controlled test features: it is designed to monitor modern VME systems using D64 and/or the VSB bus, latches all data, address and control lines in registers that can be read back over the VME bus, and generates VME interrupts on programmable levels under manual control. A performance measurement section counts VME cycles responding to selected criteria, and timing logic measures VME cycle duration. The page also lists front-panel elements such as the LED display option switch (DIP 8), the VME/VSB switch, the Sel/Mode/Clear switch, SYSRESET and INT generation push-buttons and the external TTL/NIM input. The leaflet is an advertisement page from CES in Switzerland, which invites readers to contact its Swiss and German offices for further information.
| Bus display selection | Switch selectable VME or VSB |
|---|---|
| VME address lines displayed | Including A64 |
| VME data lines displayed | Including D64 |
| Display modes | Direct, latched or monitor |
| DS to DTACK delay | Programmable in monitoring mode |
| External input signal | NIM / TTL |
| Register access | VME Slave interface |
| Display option switch | DIP 8 |
It is a VME/VSB Display and Diagnostic Module used to monitor backplane activity and measure the performance of modern VME/VSB systems.
The module supports direct, latched and monitor display modes.
It is an extension of the VMDIS 8003 that provides additional visual and computer-controlled test features.
Each can be activated by a front-panel push-button or by an external NIM/TTL signal; SYSRESET can also be generated in response to a software request.