User manual for Built In GH306SS gas hob, covering safety, installation, cleaning, and burner operation.
This user manual provides safety instructions, installation guidelines, and cleaning procedures for the Built In GH306SS gas hob. It includes details on burner specifications, automatic ignition, flame failure safety, and electrical/gas connections. Maintenance and cleaning are covered with warnings about cooling the appliance before cleaning and avoiding abrasive materials. The manual also includes technical specifications for burners and gas compatibility.
| Burner Configuration | 1 x 3.00 kW rapid burner, 1 x 1.00 kW auxiliary burner |
|---|---|
| Control Panel | Front control operation, automatic ignition, heavy duty cast iron pan stands, flame failure safety device on each burner |
| Rated Voltage | 220 - 240 Vac 50 / 60 Hz |
| Supply Connection | 3A (double pole switched fused outlet with 3mm contact gap) |
| Gas Connection | Rp ½ (ISO R7) |
Press in the control knob of the burner you wish to light and turn it anti-clockwise to the maximum position. Hold it down for 20 seconds after the flame lights, then turn it to your desired setting.
Adjust the minimum flow using a small bladed screwdriver. The correct adjustment is when the flame length is about 3–4 mm. For butane/propane gas, the adjusting screw must be tightly screwed in.
No, the manual explicitly states: 'WHERE THIS APPLIANCE IS INSTALLED IN MARINE CRAFT OR IN CARAVANS, IT SHALL NOT BE USED AS A SPACE HEATER.'
Remove the control knobs, pan supports, burners, and fixings. Disconnect the gas pipe, clean the cone and seating with solvent, lightly smear the cone with high-temperature grease, reassemble, and perform a gas soundness test.