Billi XI Slimline Font Proud & Flush Mount Installation Guide

Installation guide for the Billi XI Slimline Font, covering Proud and Flush Mount configurations with component lists, drilling instructions, and assembly…

Brand: Billi
Category: Other
Document type: Installation Guide
Language: English
Pages: 6
File format: PDF
File size: 910 KB
Published: 05 November, 2026
Updated: 05 November, 2026
MD5 checksum: 1134CF37192F5448838648C271937243
PDF: Billi XI Slimline Font Proud & Flush Mount Installation Guide PDF

About this manual

This document provides installation instructions for the Billi XI Slimline Font in both Proud and Flush Mount configurations. It details the required components, including the font tray, cover plates, gaskets, and various screws and bolts. The guide emphasizes planning the installation location based on dispenser tube lengths and drainage requirements, and specifies that installation must be performed by a licensed tradesperson in accordance with AS 3500.4.

What's inside

Installation requirements
Proud Mount procedure
Flush Mount procedure
Marking and Drilling Holes
Fitting Drain Adapter
Fitting Billi Font to Benchtop
Fit front and rear cover plates
Install the tap
Connect Tubing to Underbench Module
Connect Drainage

Specifications

Drain hole minimum diameter	ø12.7mm (1/2")
Proud Mount cut-out dimensions	191.0mm x 272.0mm
Flush Mount cut-out dimensions	191mm (wide) x 291mm (long)
Corner Radius	5mm

Frequently asked questions

Who should install the Billi Font?

The Billi Font is to be installed by a licensed tradesperson.

What standard must the installation comply with?

Installation must be in accordance with AS 3500.4 or AS/NZ 3500.4.2.

What tubing is recommended for horizontal drain runs?

We recommend 20mm or 25mm copper tubing be used for horizontal runs.

Download PDF (910 KB)