Arturia Keylab 49/61 or 25 with Pro Tools User Manual

Instructions for setting up Arturia Keylab keyboards to control Pro Tools transport functions using MIDI Machine Control (MMC).


Arturia Keylab 49/61 or 25 with Pro Tools User Manual - cover page
Brand
Arturia
Category
Other Computer Accessories
Document type
User Manual
Language
English
Pages
2
File format
PDF
File size
206 KB
Published
04 November, 2026
Updated
04 November, 2026
MD5 checksum
1FB1D0DA2A2A83B17F33A62377DB410F

About this manual

This manual explains how to use the Arturia Keylab keyboard to control Pro Tools software. It covers the necessary steps to configure Pro Tools to receive MIDI Machine Control (MMC) messages, allowing the keyboard to act as a remote transport controller.

What's inside

  • Controlling Pro Tools with your Keylab keyboard
  • Setting up your Keylab
  • Set up Pro Tools transport controls

Specifications

Minimum Firmware Version (Keylab 49/61)1.29 and above
Minimum Firmware Version (Keylab 25)1.16 and above
Supported Transport ControlsRewind, Fast Forward, Stop, Play and Record

Frequently asked questions

Does the Keylab support Loop/Cycle in Pro Tools?

No, Loop/Cycle is not in the MMC spec so it will not work in Pro Tools.

How do I reset the Keylab after updating firmware?

Reset the unit by powering up while holding down the octave up + octave down buttons.

Download PDF (206 KB)

More Arturia Manuals


View all Arturia manuals →