Installation guide for Alliance Laundry Systems stacked washer-dryers, covering water connections, gas supply (if applicable), venting, and electrical…
This manual provides installation instructions for the Alliance Laundry Systems stacked washer-dryer units. It details the necessary tools, safety warnings regarding fire and gas hazards, and step-by-step procedures for moving the unit to the installation site.
The guide covers connecting the water supply lines (hot and cold), installing drain hoses, and setting up the exhaust system. Specific sections address requirements for both electric and gas dryer models, including gas line connections and leak checks. This manual is written in Chinese.
| Water Pressure Range | 138 to 827 kPa (20 to 120 psi) |
|---|---|
| Maximum Water Flow Rate | 9.46 liters/min (2.5 gallons/min) |
| Recommended Cold Water Temperature | 10 to 24 °C (50 to 75 °F) |
| Recommended Maximum Hot Water Temperature | 51 °C (125 °F) |
No, the washer and dryer cannot be used independently or placed side-by-side.
The manual recommends a cold water temperature between 10 and 24 °C.
The water pressure must be no greater than 827 kPa.
All hoses must be replaced every five years.