ALC Bacview Service Tool User Manual

This manual explains how to connect and operate the ALC Bacview service tool with ALC controllers for monitoring, status viewing, setpoint adjustment, and…


ALC Bacview Service Tool User Manual - cover page
Brand
ALC
Category
Automation control Equipment
Document type
User Manual
Language
English
Pages
6
File format
PDF
File size
209 KB
Published
09 November, 2026
Updated
09 November, 2026
MD5 checksum
1664B2E11BAF0BE9137332348050FCC3

About this manual

The Bacview service tool connects to ALC controllers via a service cable or hard‑wired 4‑pin plug, providing access to unit status, input states, limit switches, time delays, run‑time logs, and adjustable set points. The service cable uses color‑coded wires (red +12 V, blue Rnet‑, white Rnet+, black Gnd) that plug into the controller’s local access port; alternatively, the Bacview’s 4‑pin plug can be wired directly in parallel with an existing RSpro thermostat.

Once connected, the welcome screen shows the system program number and version. Navigation uses four soft‑touch keys below the display to move between status, set point, delay, and run‑time screens. Set points are edited by highlighting the desired line, pressing Enter, then using OK/Cancel/Decrease/Increase keys. For I/O Flex 6126 controllers, network settings (Arcnet and MS/TP numbers) can be cleared or set by holding Fn+9; advanced network information (BACnet device instance and base ID) is accessed with Fn+8.

What's inside

  • General instructions for Bacview connection and use
  • Service cable connection
  • Hard wired connection
  • Welcome screen
  • Status screen
  • Setpoint screen
  • Delay screen
  • Run time screen
  • Network settings

Specifications

Connection methodService cable (4‑pin) or hard‑wired 4‑pin plug
Service cable wiring+12 V = Red, Rnet‑ = Blue, Rnet+ = White, Gnd = Black
Compatible controllersALC controllers (I/O Flex 6126, I/O Zone 583)
Set point editingHighlight line, press Enter, use OK/Cancel/Decrease/Increase keys

Frequently asked questions

How do I change a set point on the Bacview?

Use the arrow keys to move the quotes to the desired set point, press Enter to enter edit mode, then use the Decrease/Increase keys to adjust the value and press OK or Enter to save.

How do I reset network settings on an I/O Flex 6126 controller?

Hold Fn+9 to open the network screen, set the Arcnet network number to zero, then set the MS/TP network number to the desired value or to 1 to force a network search.

Download PDF (209 KB)