Operator and assembly manual for the ACCU-PRO 632 reel/bedknife grinder, covering safety, operation, daily maintenance and ANSI B7.1 grinding wheel rules.
This document combines two manuals for the ACCU-PRO 632 automatic-index reel/bedknife grinder: the Operator's Manual, which covers operating the machine and performing daily routine maintenance, and the Assembly and Maintenance Manual, which is intended for the maintenance department to install the machine and carry out all maintenance beyond routine work.
It contains safety instructions and grinding wheel rules based on the ANSI B7.1 standard, specifications (1 HP grinding head motor at 3450 RPM, 0.20 HP reel drive motor, 400 lb optional winch capacity), identification of the control panel components, operating instructions and a reel installation chart. The machine is intended only for grinding the reels of reel-type mowing units and is for indoor use. This manual is written in Chinese.
| Grinding head travel | 38 in [97 cm] |
|---|---|
| Overall width | 71 in [181 cm] |
| Overall height | 71 in [181 cm] to frame top; 85 in [220 cm] to optional boom top |
| Overall depth | 51 in [130 cm]; 91 in [232 cm] with optional workstation in down position |
| Weight | 1490 lbs [676 kg]; shipping weight 1770 lbs [803 kg] |
| Grinding head motor | 1 HP AC motor, 3450 RPM |
| Reel drive motor | 0.20 HP fan-cooled variable-speed DC motor |
| Winch/workstation capacity | Max 400 lbs [180 kg] (optional) |
| Sound level | Greater than 75 dBA, less than 95 dBA |
| Traverse switch | Solid-state non-contact proximity switch |
| Low-voltage relay | Factory preset 100-140 VAC |
It is only for grinding the reels of reel-type mowing units; any other use may cause injury and void the warranty.
The maximum capacity is 400 lbs (180 kg), as marked on the optional winch assembly.
The low-voltage relay is factory preset to 100-140 VAC; if the wiring cannot supply 100-140 VAC under load, the relay disconnects and stops the starter.
Every wheel must be visually inspected for damage before installation, and the machine speed must be checked against the wheel's marked maximum safe operating speed.