W320 Net In Center Control System Program Solutions Manual

W320 central control unit setup program is a software used to set up Shenzhen Pengxun network series central control unit, the software uses the previous simple and friendly interface, increase the template based setting method, easy to quickly set up.

Brand: W320
Category: Automation control Equipment
Document type: User Manual
Language: Chinese
Pages: 50
File format: PDF
File size: 963 KB
Updated: 30 September, 2023
Model: W320
MD5 checksum: DAFC51BF1156CDFBA44E743C7244993D
PDF: W320 Net In Center Control System Program Solutions Manual PDF

About this manual

The document describes how to install the W320 control program, including running Setup.exe and following the on‑screen prompts. It also covers uninstalling the software via the Windows Control Panel.

Further sections explain the user interface, system toolbar, workspace layout, parameter settings, and how to modify or repair the program. A FAQ at the end addresses common errors and troubleshooting steps. This manual is written in Chinese.

What's inside

Overview
Installation
Program Execution
Interface Introduction
System Toolbar
Workspace
Parameter Settings
Program Modification
Appendix
FAQ

Specifications

CPU	Pentium III 450 MHz or higher
Memory	Minimum 64 MB, recommended 128 MB or more
Disk space	Typical installation 40 MB

Frequently asked questions

How do I install the W320 control program?

Run Setup.exe from the installation media and follow the prompts to complete the installation.

How can I uninstall the W320 program?

Open Control Panel → Add/Remove Programs, select the W320 entry, and follow the prompts to uninstall.

What should I do if the program fails to start?

Check that the serial port is correctly connected and that the Windows operating system version is supported (Windows 2000, 2003, etc.).

Download PDF (963 KB)