The IS300 series servo drive is a servo drive specifically developed for driving permanent magnet synchronous servo motors (PMSM). It has a wide capacity range (rated current 5A~300A) and is suitable for servo pump control and general servo function requirements. This manual is the operation guide for the IS300 series servo drive, providing instructions and guidelines for selection, installation, parameter setting, on-site debugging, fault diagnosis, and maintenance.
This manual covers safety information, proper installation, mechanical and electrical wiring, and operation of the IS300 series servo driver. It includes detailed instructions for parameter configuration, servo oil debugging, and EMC compliance.
Additional sections describe routine maintenance, fault diagnosis, and the warranty agreement, helping users keep the device running safely and reliably. This manual is written in Chinese.
| Minimum insulation resistance (test) | ≥5 MΩ |
|---|
Confirm that the power‑supply voltage matches the driver’s rated voltage, verify that all wiring is correct and check for any short circuits before applying power.
Maintenance must be carried out only after the charge indicator is off and only by qualified personnel; never perform maintenance on a powered unit.
The product is covered by an 18‑month warranty, as stated on the warranty card.