IBM PowerHA SystemMirror for AIX v7.1 Two-Node Quick Configuration Guide

This document describes how to quickly configure a two-node hot-standby PowerHA v7.1 cluster, primarily using SMIT.


IBM PowerHA SystemMirror for AIX v7.1 Two-Node Quick Configuration Guide - cover page
Brand
IBM
Category
Other software
Document type
Installation Guide
Language
English
Pages
34
File format
PDF
File size
925 KB
Published
30 November, 2023
Updated
30 November, 2023
MD5 checksum
848DCB951190BC84055905AEEBD613DC

About this manual

This IBM guide, written by Shawn Bodily in November 2012, gives the steps to quickly configure a two-node hot-standby PowerHA SystemMirror for AIX v7.1 cluster, primarily using SMIT. It lists the prerequisites for a new cluster, then walks through the Initial Cluster Setup (Typical) menus, defining the cluster repository disk and multicast cluster IP address, and synchronizing the cluster configuration so the CAA cluster is created.

What's inside

  • Introduction
  • Configuring the Cluster
  • Configuring VLAN 3358 for SAN heartbeat
  • Testing the Cluster
  • References
  • Appendix A – Cluster Test Tool Log

Specifications

PowerHA level used in the sample clusterPowerHA Version 7.1.1 SP3
AIX level used in the sample clusterAIX 7.1, TL 1, SP 3
RSCT level3.1.2
Compute nodesOne p260 and one p460 with 8GB Fibre Channel Mezzanine Adapters
Storage in the sample environmentV7000 Storage
VLAN used for SAN heartbeat3358
Multicast address created automatically in the sample228.23.17.35
Required CAA filesetsbos.cluster and bos.ahafs

Frequently asked questions

What is the purpose of this guide?

It provides the steps to quickly configure a two-node hot-standby PowerHA v7.1 cluster, mainly using SMIT menus.

Which SMIT path starts the cluster creation?

Enter smitty sysmirror, then Cluster Nodes and Networks, then Initial Cluster Setup (Typical), then Setup a Cluster, Nodes and Networks.

Is multicasting required for the cluster IP address?

In PowerHA v7.1.0 to v7.1.2 multicasting is required; in v7.1.3 unicast was re-introduced, making multicast optional.

What VLAN is used for the SAN heartbeat?

A virtual Ethernet adapter with VLAN id 3358 is created on the client LPAR and on each VIOS partition for the CAA SAN heartbeat.

Download PDF (925 KB)

More IBM Manuals


View all IBM manuals →