This document describes how to install a rack.
This guide provides installation instructions for trained service technicians installing systems in an open-frame relay rack or rack cabinet. It covers safety precautions, rack requirements, recommended tools, RapidRails and VersaRails kit contents, and installation tasks for four-post and two-post racks.
Procedures include marking the rack, installing mounting rails, installing the system, routing cables, using releasable tie wraps, removing the system, and replacing rack doors.
| Rack unit height | 1 U = 44 mm (1.75 inches) |
|---|---|
| VersaRails mounting screws | 10-32 x 0.5-inch flange-head Phillips screws (8) |
| RapidRails installation | No tools required in Dell rack cabinets |
| Rack AC load limit | Not more than 80 percent of branch circuit rating |
A #2 Phillips screwdriver and masking tape or a felt-tip pen.
1 U, or 44 mm (1.75 inches).
ANSI/EIA-310-D-92, IEC 297, and DIN 41494.
No; never pull more than one component out on its slide assemblies at one time.