This document describes the methods for miRNA Sample Preparation and miRNA CodeSet Hybridization.
The NanoString nCounter miRNA Expression Assay is a research-use-only method for detecting miRNAs without reverse transcription or amplification. It runs on purified total RNA from sources including FFPE samples and uses NanoString molecular barcodes, with sample processing that anneals and ligates unique oligonucleotide tags to miRNAs via a target-specific bridge oligo before CodeSet hybridization and counting on an nCounter system.
Workflow includes miRNA sample preparation and CodeSet hybridization setup, with less than 45 minutes of hands-on time and data analysis in under 24 hours. Reagents are supplied in 12-reaction aliquots, and Master Kits or SPRINT Reagents and Cartridges are required and sold separately.
| Recommended total RNA input | approximately 100 ng |
|---|---|
| RNA sample concentration | ≥ 33 ng/µL |
| A260/A280 ratio | 1.9 or greater |
| A260/A230 ratio | 1.8 or greater |
| Recommended hybridization time | 16-24 hours |
| Hands-on time | less than 45 minutes |
| Day 1 workflow time | 2 hr total |
| Thermal cycler heated lid offset | 5°C greater than current incubation temperature |
| Thermal cycler heated lid maximum | 110°C |
| miRNA Assay Controls dilution | 1:500 |
Purified total RNA is required, and NanoString recommends approximately 100 ng for most tissue and cell isolates.
Yes, total RNA purified from formalin-fixed, paraffin-embedded material may be used.
A 260/280 ratio of 1.9 or greater and a 260/230 ratio of 1.8 or greater.
All experiments should be designed in sets of 12 samples.