This standard specifies the general technical requirements, test methods and acceptance rules for arc welding machines.
GB/T 8118-2010 is a Chinese national standard that establishes general technical conditions for arc welding machines intended for industrial and professional use. It covers requirements for basic parameters, operating conditions, technical performance, inspection methods, and acceptance rules. The standard applies to welding machines supplied by voltages per GB/T 156 or mechanically driven, but excludes limited-load manual arc welding power sources for non-professional use.
The 2010 revision replaces GB/T 8118-1995 and introduces changes including updated normative references, modified rated minimum welding current limits, revised operating conditions, added requirements for wire feeders, welding torches, electrode holders, power factor, electromagnetic compatibility, and no-load current limits for manual arc welding machines. It also specifies noise limits based on rated current and cooling fan presence, and references multiple safety standards for welding power sources, wire feeders, torches, electrode holders, and cable couplers. This manual is written in Chinese.
| Rated current levels | 10–2000 A per R10/R5 series |
|---|---|
| Rated duty cycle | 20, 35, 60, 80, 100 % |
| Working cycle | 10 min or continuous |
| Cold/hot state variation | ≤ ±5% |
| No-load current (manual arc) | ≤ 10% of rated input current |
Recommended rated current levels follow R10 series above 100 A and R5 series below 100 A, ranging from 10 A to 2000 A.
Noise limits vary by rated welding current and fan presence, e.g., 70 dB(A) for 100 A without fan, up to 97 dB(A) for 630 A with fan.