The NCSP3 is an RV control and monitoring system with the following features: - Patented design - Easy to use - Safe and reliable - Powerful
This manual covers installation, wiring, setup, and operation of the iN-Command NCSP3 RV control and monitoring system, including the Display Commander and Body Control Module.
It also describes travel lockout, mobile device pairing, HVAC, generator start, software update, global connect, calibration, and troubleshooting.
| Operating power | 12 V DC, negative ground |
|---|---|
| Display Commander cutout | 4.33 in x 6.63 in |
| Clearance below Display Commander | At least 2.75 in |
| DC to BCM wire | Minimum 24 gauge |
| Power and slide wire | 10 gauge |
| Other connection wire | 14 and 18 gauge |
| Display Commander mounting screws | Four #8 PH (0.164 in x 0.75 in) |
| Body Control Module mounting screws | Six #8 PH (0.164 in x 1.0 in) |
| Simultaneous mobile control | Up to 3 Android and 1 iOS device |
| Interior lighting zones | 4 |
| Exterior lighting zones | 3 |
| Auxiliary triggers | 4 programmable 12 V |
| Alarm inputs | 4 (12 V) |
It is designed for a 12 volt DC, negative ground battery system.
Up to three Android devices and one iOS device can control it simultaneously.
Lights, water pump, water heater, generator, and tank sensors continue to function.
Press Disengage on the Display Commander after the brake signal is removed.