This document describes how to connect an iPod Touch or iPhone to UNAM's wireless network.
This guide is published by the Dirección General de Cómputo y de Tecnologías de Información y Comunicación of the Universidad Nacional Autónoma de México (UNAM) for the Red Inalámbrica Universitaria (RIU). It describes the steps needed to configure an iPod Touch or iPhone so it can connect to the RIU, and it states that the device must have firmware version 2.0 or higher. It also notes that the configuration must be done while the device is inside an area covered by the RIU signal.
The guide walks through opening Ajustes, choosing Wi-Fi, selecting the RIU network, confirming that the configuration uses DHCP, and entering the user name and password provided by the department. It then explains accepting the certificate prompt, which the document says only validates connections to the RIU server, and how to confirm a successful connection when the RIU network name turns blue and is marked with a check. Contact addresses for comments, suggestions and user support are given at the end. This manual is written in Spanish.
| Required firmware version | 2.0 or higher |
|---|---|
| Network configuration method | DHCP |
| Wireless network name | RIU |
The device needs firmware version 2.0 or higher. The guide explains how to check the version under Ajustes, General, Información.
The configuration must be set to DHCP. The guide asks you to verify this before continuing.
After a few seconds the RIU network name turns blue and is marked with a check, and from then on you can browse and use the network services.
The guide gives the email address [email protected] and the user support site www.ayuda.telecom.unam.mx.