The core of the Heliomotion power plant is the dual-axis tracker. The tracker is designed to be mounted with either photovoltaic or thermal solar collectors and can carry a panel area of up to 10.5 m². Tracker There are four standard applications for the tracker: PV-2M, PV-3M, PV-4M and PV-6M. These models use photovoltaic solar panels for power generation.
This manual from Heliomotion covers the installation, operation and maintenance of the Heliomotion Solar Power Plants and the Heliomotion Tracker. The core of the power plant is a dual-axis tracker that can be mounted with photovoltaic or thermal solar collectors and can carry a panel area of up to 10.5 m². Four standard PV applications are described: PV-2M, PV-3M, PV-4M and PV-6M.
Installation chapters give recommendations for site selection, cement foundations, the extension column, wiring, power options and commissioning, noting that the electrical part must be carried out by a certified electrician. Operation is fully automatic after a GPS fix, with safety handling for obstacles, an internal clock backup, a USB service interface for the Heliocom tool, and LED status indicators.
| Panel area capacity | Up to 10.5 m² |
|---|---|
| Standard PV applications | PV-2M, PV-3M, PV-4M, PV-6M |
| Input voltage range | 24 VDC ± 20% |
| Default motor torque | 5 Nm |
| Default rotation speed | 5 minutes for 180 degrees |
| Tracking movement interval | 1.8 degrees every couple of minutes, positioned 0.9 degrees ahead of the sun |
| Wind speed withstand (free standing foundation) | Up to 30 m/s |
| Extension column length | 1.5 meter |
| Recommended wire cross section | 2.5 mm² up to 40 m; 6 mm² up to 100 m |
| Clock backup battery | 3V lithium cell |
The tracker can be powered from any constant 24 VDC source, such as a 24 V battery bank or a 24 VDC transformer from the grid, with an input voltage range of 24 VDC ± 20%.
It pauses its normal operation for an hour and then tries to rotate again. The low default motor torque of 5 Nm lets a person or obstacle stop the rotation without damage or injury.
There are no parts requiring lubrication or scheduled maintenance procedures; an annual visual inspection is recommended, checking that bolted joints are tight and the panels are clean.
Motor torque, motor speed and pause duration can be adjusted using the Heliocom software, connected to the circuit board through a USB connector.
Yes. An internal clock with a replaceable 3V lithium backup battery and the stored latitude/longitude settings let the tracker keep operating for many years.