Relationship between Wrist Joint Position and Grip Strength - Rigaku Ryoho Journal Vol.13 No.6 (1986)

The relationship between wrist joint position and grip strength was investigated. The results showed that the maximum grip strength appeared at about 20° of dorsiflexion and 0° of radial deviation.


Relationship between Wrist Joint Position and Grip Strength - Rigaku Ryoho Journal Vol.13 No.6 (1986) - cover page
Category
Other
Document type
Other
Language
Japanese
Pages
5
File format
PDF
File size
675 KB
Published
15 November, 2023
Updated
15 November, 2023
MD5 checksum
CD7BD3EFE76628084B6A82DEE8066DA8

About this manual

This is an academic research report (報告) published in the Japanese journal 理学療法学 (Journal of Physical Therapy), Volume 13, Number 6, 1986, pages 409-413, under the title 手関節肢位と握力の関係について (Relationship between the Wrist Position and the Power Grip Strength). The authors were affiliated with the Tokyo Metropolitan Fuchu Rehabilitation School, the Tokyo Metropolitan Institute of Gerontology, and the Tokyo Metropolitan College of Allied Health Medical Science.

The study examined 22 healthy right-handed adults and measured grip strength with a Smedley dynamometer in 13 wrist positions combining palmar/dorsiflexion and radial/ulnar deviation, using a custom fixation device. Maximum grip strength occurred at about 20 degrees of wrist dorsiflexion with slight ulnar deviation; grip decreased in any direction from this position, with a marked decrease in palmar flexion. The paper discusses manual muscle testing (MMT), grip measurement methods, and the clinical implications for grip strength testing and strengthening training. This manual is written in Japanese.

What's inside

  • 要旨 (Abstract)
  • はじめに (Introduction)
  • 対象と方法 (Subjects and Methods)
  • 結果 (Results)
  • 考察 (Discussion)

Frequently asked questions

How many subjects were studied and which hand was tested?

The study covered 22 healthy adults, all right-handed, and grip strength was measured on the dominant right hand.

Which wrist position produced the maximum grip strength?

Maximum grip strength was found at about 20 degrees of wrist dorsiflexion with slight ulnar deviation from the neutral radioulnar position.

What instrument was used to measure grip strength?

A Smedley-type grip dynamometer was used, with the grip opening set to half the distance from the thumb base to the tip of the index finger.

How did grip strength change in palmar flexion?

Grip strength decreased whenever the wrist was moved away from the optimal position, and the decrease was especially marked in palmar flexion.

Download PDF (675 KB)

Also Manuals