This document describes the steps on how to convert an OMC Cobra SE116 to 813.925.7127.
This Sterndrive Engineering SE116 conversion kit guide explains how to remove an OMC Cobra drive and bell housing and install the new SEI bell housing and SE116 drive. The instructions are organized into eight main steps, from removing the old drive through adjusting the shift and bypassing the OMC ESA module.
The guide states that the kit is designed for OMC Cobra drives that use a clutch dog in the lower unit and that SEI recommends and warrants use only in applications not exceeding 300 HP. It also recommends disconnecting the battery before starting the conversion and includes optional, untested additions such as a remote oil reservoir and speedometer hookup.
| Maximum application power | 300 HP |
|---|---|
| Designed replacement | OMC Cobra drives that use a clutch dog in the lower unit |
| Shift cable barrel-to-eyelet measurement | 6 inches |
It is designed to replace OMC Cobra drives that use a clutch dog in the lower unit.
SEI recommends and warrants use only in applications not exceeding 300 HP.
The measurement should be exactly 6 inches, rotating the brass barrel until it is.
It is recommended to disconnect the battery before starting the conversion.