This document provides the installation instructions and owner's manual for the SIDE MOUNT BOAT CONTROL CH2200P (SKI BOAT) / CH2300P (JET BOAT).
Published as Part # IS-CH2200/2300, Rev 1, 08/2013, this 12-page manual covers installation and owner instructions for SeaStar Solutions CH2200P and CH2300P side mount single-lever boat controls. The CH2200P is intended for ski boats and the CH2300P for jet boats; the CH2300P has limited-travel throttle warm-up movement to prevent boat travel while in neutral.
The manual describes preparing the mounting location, routing and supporting cables, connecting throttle and shift cables, adjusting the throttle brake, installing a neutral safety switch, mounting the mechanism and handle, and connecting cables to the engine. It lists required 3300/33C control cables and notes that a neutral safety switch is standard on CH2300P controls, while CH2200P does not provide “Start in Gear” protection. It also recommends an engine shut off switch as an emergency safety feature.
| Maximum mounting surface thickness | 1/2 in |
|---|---|
| Minimum bend radius, Standard 3300/33C cable | 8 in |
| Minimum bend radius, Xtreme 3300/33C cable | 4 in |
| Throttle cable terminal protrusion | 5/32 in (5 threads) |
| Handle spline tooth count | 48 teeth per spline set |
| Handle indexing increment | 7.5° |
The CH2300P has limited-travel throttle warm-up movement for jet boat applications, which prevents boat travel while in neutral.
A neutral safety switch is standard on CH2300P controls. The CH2200P does not provide “Start in Gear” protection unless the switch is added.
Two 3300/33C Series Control Cables are required for a complete control system.
No. SeaStar Solutions recommends an engine shut off switch, but it is not a standard part of the control.