This document describes the maintenance procedures for the CDFI1000P, CDFI500P, CDFI1000-PRO and CDFI500-PRO fireplaces.
This service manual covers the Dimplex CDFI1000P, CDFI500P, CDFI1000-PRO and CDFI500-PRO Optimyst cassettes, which create a flame and smoke effect using water mist with wood fire sound effects. It lists the part numbers for each model (6909660100, 6909660200, 6909660300 and 6909660400) and states that repairs should always be carried out by a qualified technician or service agency.
The manual describes operation of the controls (On/Off switch, standby, Bluetooth pairing, flame intensity and volume), remote control synchronization, and maintenance such as filling the refillable water tank, transducer replacement, filter and surface cleaning. It also includes exploded parts diagrams, replacement parts lists with part numbers, wiring and water flow diagrams, step-by-step service instructions for board, fan, heating element, sensor and valve replacement, a troubleshooting guide and a test mode section.
| Remote control batteries | Two 1.5 Volt (AAA) batteries |
|---|---|
| Remote synchronization capacity | Up to 5 units per remote control |
| Spare transducers included | 2 additional transducers located behind the right module |
Normal tap water can be used as long as it is not hard water. If your tap water is hard, use softened water or distilled water with 1/8 tsp (0.5 mL) of salt added to the reservoir.
Press the Bluetooth synchronization button on the primary controls, then within 20 seconds press any button on the remote control. If successful, the LEDs blink 5 times and beep 5 times before the unit returns to standby.
The top cover assembly, sump and transducer should be cleaned with soap and water on a biweekly basis. Air filters can be rinsed with water, dried and reinstalled.
Empty and drain the unit of water and dry all water-containing components before relocating or leaving it unused.