LEADSUN Solar Light User Manual, introduces the installation, use and maintenance methods of LEADSUN Solar Light.
This user manual describes the LEADSUN AE3 Series Solar Light, an all-in-one solar lighting system with an integrated photovoltaic module, lithium battery, infrared sensor and controller. It lists the parts supplied with the all-in-one and split type versions, gives the warning and caution notes for transport, storage and working conditions, and explains the function of each part of the unit.
The manual explains the OFF, transport (idle) and ON working modes, daytime and night start-up, and the short press and 5 second long press button operations. It then gives step-by-step activation and installation instructions for the all-in-one and split type units, including panel orientation and angle, and closes with maintenance notes and a troubleshooting table.
| Product protection grade | IP65 |
|---|---|
| Working temperature range | -20°C to 60°C |
| Charging temperature range | 0°C to 60°C |
| Wind speed resistance | up to 180 km/hr |
| Typhoon resistance | level 3 typhoon (58 m/s) |
| Light photosensitivity | around 30 lx |
| Storage temperature | 0°C to 45°C |
| Maximum torque for M8 bolts | 14 Nm |
| Recommended solar panel angle, Australian southern states | 43° |
When the lighting condition is sufficient (over 30 lx), the light illuminates for 20 seconds and then turns off; it will then work normally from that night.
Use the night start-up mode: hold the button down for 5 seconds.
All internal parts are waterproof and the unit is rated to IP65.
When the air temperature is close to human body temperature, motion detection may slow down and returns to normal after the air temperature changes.
It is out of motion detection range when the installation height exceeds 8 m, so a lower height or another operating mode is recommended.