This document is an installation manual for a car drinking system. The drinking system is produced by Manthey-Racing GmbH and the models are “Sprint” and “Endurance”.
This installation manual covers the Manthey-Racing drinking systems “Sprint” and “Endurance”. It lists the scope of delivery for both versions and describes mounting the AS Carbon housing with the supplied bracket or directly to the car body, routing the drinking hose to the driver's-side B-pillar, and fitting the quick coupling.
The manual also gives safety warnings, pump connection information for the 5-pin connector, handling instructions for inserting and removing the bottle, care instructions, and the available connection-position variants for both systems.
| AS Carbon housing tightening torque | 10 Nm |
|---|---|
| Clamping tightening torque | 1.5 Nm |
| Pump connector pin 1 | +12 Volt (red cable) |
| Pump connector pin 2 | ground (blue cable) |
| Pump connector pins 3-5 | not used |
| Pump circuit fuse | 3 Ampere |
The manual covers the “Sprint” and “Endurance” drinking systems.
The AS Carbon housing should be tightened to 10 Nm.
The pump circuit must be protected with a 3 Ampere fuse.
For hygienic reasons, the system must be cleaned after each use.