Mings MET-A07 Onboard Preamp User Guide

The MET-A07 is a preamp with the following features: 1. The volume knob can be set to a high level without causing distortion or feedback. 2. The bass knob can add depth and weight to the sound of the guitar. 3. The middle knob can adjust the mid-range of the sound. 4. The treble knob can adjust the high-range of the sound. 5. The presence knob can control the frequency between 15K-20K. 6. The Notch knob can suppress feedback.


Mings MET-A07 Onboard Preamp User Guide - cover page
Brand
Mings
Category
Musical instruments
Document type
User Manual
Language
English
Pages
1
File format
PDF
File size
514 KB
Published
06 November, 2023
Updated
06 November, 2023
MD5 checksum
AECC393F56DAC59B62EB9C55EABF64A7

About this manual

This is the user guide for the Mings MET-A07 onboard preamp. It walks through the basic setup in three steps: setting the controls, connecting the preamp to an amplifier or PA with a ¼-inch instrument cable, and raising the volume while adjusting the bass, middle, treble and presence controls.

The guide then describes each control, including volume, bass, middle, treble, presence, the notch anti-feedback control, the tuner display with chromatic, guitar and bass modes, pitch setting from 433 to 447 Hz, and 9-volt battery replacement. A specification section lists input and output levels, impedance, THD, noise floor, dynamic range, battery life and control frequencies.

What's inside

  • Quick Start
  • Controls
  • Volume
  • Bass
  • Middle
  • Treble
  • Presence
  • Notch
  • Power and tuner display
  • Note (chromatic / guitar / bass mode)

Specifications

Nominal Input Level-20dBV
Output Impedance3.5K Ohm (20Hz-20KHz)
Nominal Output Level-12dBV
THDLess than .05% (-20dBV input)
Noise Floor-97dB
Dynamic Range102dB
Battery Life60 hours (EQ working, tuner off)
Bass Control Frequency60Hz
Middle Control Frequency500Hz
Treble Control Frequency3KHz
Pres Control Frequency10KHz point control (±7dB, Q=1)
Pitch Range433 – 447 Hz, step 1 Hz
Battery Type9-volt battery

Frequently asked questions

How do I connect the MET-A07 to an amplifier?

Connect the MET-A07 to an amplifier or PA with a ¼-inch instrument cable. The battery light flashes once quickly to show it has switched on.

What battery does the MET-A07 use and how is it replaced?

It requires a 9-volt battery. Draw out the battery case next to the input jack and replace the battery according to the +/- sign.

How do I set the volume for the cleanest signal?

Set the volume knob as high as possible without causing distortion or feedback.

What is the pitch range of the tuner?

The pitch is adjustable from 433 to 447 Hz in 1 Hz steps.

Download PDF (514 KB)