XR70CH is a Dixill mini electronic temperature controller that can be used for medium/low temperature forced air cooling systems. It has four outputs: one compressor, one evaporator fan, and one defrost (electric or hot air), and one can be defined for lighting, alarm relay output, or auxiliary output. It can provide up to four NTC or PTC probe inputs: one for the warehouse temperature, one for the evaporator temperature (defrost termination temperature + fan stop temperature control), one optional digital switch input can also connect to the third temperature probe input (this is an optional item that needs to be specified when ordering; it can be selected by parameters whether to use it); the fourth probe input (it can also be selected by parameters whether to use it), connected to the 5-pin hot key programming key interface 2, 4 No. (left or right number can be) terminal (need to plug in converter), it can be used to measure condensation temperature alarm or to display the temperature of a certain point; the hot key programming interface can be connected to the programming key, and can be connected to the XJ485-CX communication conversion module with ModBUS-RTU protocol compatible network, such as the Dixill XWEB series monitoring system. It can be set up on the panel keyboard or by the programming key (HOT KEY) to quickly copy parameters.
The Dixill XR70CH is a miniature electronic temperature controller for medium or low temperature forced air-cooling refrigeration systems. It has four outputs: one compressor, one evaporator fan, one defrost output, and one user-definable output.
The controller can accept up to four NTC or PTC probe inputs and can communicate through a programming key or an optional communication module using Modbus-RTU. Its manual includes notes, output control, keypad operation, temperature value storage, features, and parameters. This manual is written in Chinese.
| Outer dimensions | 32 x 74 x 60 mm |
|---|---|
| Compressor hysteresis | 0.1°C to 25.5°C |
It has four outputs: one compressor, one evaporator fan, one defrost output, and one user-definable output.
The compressor runs when the measured temperature is at or above the setpoint plus Hy, and stops when it is at or below the setpoint.
Up to four NTC or PTC probe inputs are supported, with some optional or configurable.