ZhiXingWei ZX-D29 Single-Mode Test Kit User Manual

ZX-D29 single-mode test kit user manual, including product introduction, bottom board pin diagram, AT command test, APP/WeChat mini program test and other content


ZhiXingWei ZX-D29 Single-Mode Test Kit User Manual - cover page
Brand
智兴微 (ZhiXingWei)
Category
Test Set
Document type
User Manual
Language
Chinese
Pages
11
File format
PDF
File size
1.3 MB
Published
03 November, 2023
Updated
03 November, 2023
MD5 checksum
CF69174FF359ED4AD77A2B9D532A139D

About this manual

The ZX-D29 single-mode test kit from Shenzhen ZhiXingWei Technology is a testing tool supplied to customers. According to the manual, the kit contains one microUSB data cable, one Bluetooth module mounted on a baseboard, and one USB-to-serial board. The manual describes the baseboard pin assignments (STATE, RXD, TXD, GND, VCC and KEY) and shows how the Bluetooth module is cross-connected to the USB-to-serial board.

The guide then walks through three test routes: sending AT commands from a PC through the serial assistant software, testing with a WeChat mini-program, and testing with BLE apps on Android (the vendor's BLE tool) and iOS (LightBlue). The document is version V1.0, dated 2023/02/10, and ends with the company's contact details. This manual is written in Chinese.

What's inside

  • ZX-D29 测试套装介绍
  • 概述
  • 底板引脚示意图
  • AT 指令测试
  • APP/微信小程序测试
  • 微信小程序测试
  • 安卓 BLE APP 测试
  • 苹果 BLE APP 测试
  • 联系我们

Specifications

Kit contentsOne microUSB data cable, one Bluetooth module with baseboard, one USB-to-serial board
VCC input voltage range3.2–6 V
Default baud rate9600
STATE pinConnection status pin: low when not connected, high after connection (may be left floating)
KEY pinShort low press disconnects; long press of 3 seconds restores factory settings
Document versionV1.0, dated 2023/02/10

Frequently asked questions

What is included in the ZX-D29 test kit?

The kit contains one microUSB data cable, one Bluetooth module with baseboard, and one USB-to-serial board.

What is the default baud rate for AT command testing?

The default baud rate is 9600 when using the ZhiXingWei serial debugging assistant.

How do I restore the Bluetooth module to factory settings?

Press and hold the KEY pin low for 3 seconds to restore factory settings.

Which app is used for the Apple BLE test?

The manual uses the LightBlue app downloaded from the Apple App Store.

Download PDF (1.3 MB)