This application note describes the difference between TM57PA20 and TM57PA20A and provides program conversion instructions
This application note (Rev 1.0, November 2013, document AP-TM57PA20&PA20A_01S) describes the Tenx TM57PA20 and TM57PA20A microcontroller ICs and the differences between them. It covers operating frequency (TM57PA20 at 4MHz; TM57PA20A at 4MHz and 8MHz), the RESET/PAT pin, the config word stored in ROM addresses 7FCH~7FFH, and PAT pull-up resistor values.
The note also explains how to convert TM57PA20 assembly projects into TM57PA20A code using the TICE99 IDE (Version V1.0.4 Build9). It walks through the "Convert To TM57PA20A" command in the Tools menu with screenshots of each step, notes that a failed conversion results when hex address 7FCH~7FFH already contains data, and ends with a table of PAT pull-up resistor differences between the two ICs. This manual is written in Chinese.
| Operating frequency (TM57PA20) | 4 MHz |
|---|---|
| Operating frequency (TM57PA20A) | 4 MHz / 8 MHz |
| Config word ROM address | 7FCH~7FFH |
| PAT pull-up resistor (Rp) | VDD=5V: 15K (TM57PA20) / 60K (TM57PA20A); VDD=3V: 20K / 100K |
In TICE99 IDE (Version V1.0.4 Build9), use the "TM57PA20 Convert To TM57PA20A" command in the Tools menu; on success the checksum is recalculated automatically.
Conversion fails when hex address 7FCH~7FFH already contains data; check and clear that ROM area before converting again.
At VDD=5V the values are 15K for TM57PA20 and 60K for TM57PA20A; at VDD=3V they are 20K and 100K.