V8M 6x8-inch Mini Slim Powered Subwoofer User's Manual

This manual introduces the features and usage of the 6x8 inch mini slim powered subwoofer


V8M 6x8-inch Mini Slim Powered Subwoofer User's Manual - cover page
Category
Car Speakers
Document type
User Manual
Language
English
Pages
8
File format
PDF
File size
575 KB
Published
03 November, 2023
Updated
03 November, 2023
MD5 checksum
5F32EA6D63A32066976F2FE1365E418F

About this manual

This is the user's manual for the V8M, a 6x8-inch mini slim powered subwoofer rated at 100W RMS with a 4-ohm subwoofer, a 20A fuse and panel dimensions of 260 x 195 x 72 mm. It explains the panel controls, including the power status LED, phase shift switch, auto power on, low pass filter, bass boost, input gain control and the remote level control port, and shows the high level (speaker level) and low level RCA inputs, fuse and power input terminal.

The manual gives wiring diagrams for low level and high level input connections, power connections to the battery, chassis ground and remote turn-on terminal, and the remote level control connection. It ends with a specifications table and a troubleshooting list that pairs symptoms such as no output, distorted sound, hiss, squealing noise and overheating with possible remedies. A Chinese version of the same content follows the English pages.

What's inside

  • Panel controls and features
  • Low level input wiring
  • High level input wiring
  • Power connections
  • Remote level control connection
  • Specifications
  • Troubleshooting

Specifications

RMS power100W
THD<0.4%
Signal-to-noise ratio>90dB
Frequency response20Hz - 150Hz
Input sensitivity, high level1.0V
Input sensitivity, low level300mV
Low pass filter50Hz - 150Hz
Bass boost0 to + 12dB
Subsonic filter20Hz
Subwoofer6x8 inch, 4 ohm
Fuse rating20A
Dimensions (L x W x H)260 x 195 x 72 mm

Frequently asked questions

Can I connect both the high level and low level inputs at the same time?

No. The manual states that both input types from the receiver must not be connected to the amplifier at the same time.

How do I set the input gain control?

Turn the control to minimum, run the head unit at about 2/3 volume, then slowly raise the subwoofer input gain until a small amount of distortion is heard and reduce it until the distortion is gone.

How long should the ground wire be?

Connect the ground terminal to the closest point on the vehicle chassis and keep the ground wire shorter than 39 inches (100 cm), using 8 gauge or heavier wire.

What should I check if the amplifier will not power up?

The manual advises checking the ground connection, the remote input voltage, battery power on the positive terminal and all fuses.

Download PDF (575 KB)

Also Manuals