Instructions for maintenance and service of 817 WTP / 818 WTP
This manual describes the ELME Servicebox for the 817 WTP / 818 WTP spreaders and gives the information needed to service and maintain a spreader at the 5,000 hour service. It covers the twistlock assembly, wear pads, back-up parts and a summary of all parts included in the box, and it states that maintenance may only be carried out by qualified personnel.
The step-by-step procedures show how to remove the tie-rod, twistlocks and sleeves, how to inspect parts before reassembly and how to fit twistlocks again, followed by seated / landed signal adjustment and twistlock angle adjustment. Closing pages explain the purpose of the servicebox, why ELME genuine parts should be used, and how to download manuals for all serviceboxes from the ELME website.
| Service interval covered by the box | 5,000 hour service |
|---|---|
| Twistlock securing screw tightening torque | approx. 25 Nm |
| Force needed to lift the seated pin | approx. 10 kg (20 lbs) |
| Seated signal switching position | pin protruding approx. 9 mm below the landing surface; 8-10 mm distance |
| Twistlock head angle in LOCKED position | 900+/- 100 to the twistlock sleeve |
| Tie rod | Fixed unit, not adjustable (does not apply for WTP) |
The box contains twistlock kits, seated pins, tie rods, nuts, washers, brackets, indicator arms and springs, wear pads for mainframe, extension beam, extension cylinder, WTP beam and carriage, plus back-up parts such as proximity switches and seal kits.
Maintenance may only be carried out by qualified personnel.
After fitting the securing screws and removing the alignment pins, the securing screws can be tightened to approx. 25 Nm.
They are available on the ELME website, elme.com, under About Us/Downloads.