This document is a troubleshooting guide for common SMT assembly issues.
This guide from Alpha Assembly Solutions provides troubleshooting advice for common SMT assembly issues by process defect. Its table of contents covers defects such as bridging, non-wet open, insufficient fill, insufficient solder, random solder balls, tombstoning, voiding, BGA head-on-pillow, and grainy joints.
Each section describes possible causes and recommendations related to areas such as PCB, stencil, screen printer, component placement, reflow profile, and solder paste. The guide advises contacting an Alpha representative if an issue is not resolved after following the steps.
Bridging is solder connecting, in most cases misconnecting, two or more adjacent pads that come into contact to form a conductive path.
A non-wet open, also called non-wet or lifted ball, occurs when the solder sphere and solder paste on the BGA have no physical contact with the pad after reflow.
A grainy joint, sometimes called 'Cold Solder,' is recognized by dark, non-reflective, rough surfaces from an alloy that is normally bright and shiny.
The guide recommends ensuring the alloy cooling rate from molten solder is 3-8°C/sec.