This document is the processing guide of Isola Group, which contains the processing advice of Isola Group's prepreg bonding sheets.
This Processing Guide from Isola Group provides starting-point guidelines for fabricators using Isola IS410 lead-free epoxy laminate and prepreg. It covers prepreg storage and handling, innerlayer preparation, dimensional stability, imaging and etching, bond enhancement, lamination, and drilling.
The document states that its suggestions are starting points that require adjustment for the particular PWB fabrication environment and board design. It also says the fabricator, not Isola, is ultimately responsible for the process and end results.
| Vacuum time | 20 minutes |
|---|---|
| Curing temperature | 185°C (365°F) |
| Curing time | 75 minutes above 185°C (365°F) |
| Lamination pressure | 200-250 PSI 14-17 kg/cm2 |
| Heat ramp | 2.2-4.5°C/min (4.0-8.0°F/min) |
| Maximum cutting speed | 550 to 600 SFPM |
| Maximum chipload | 3.5 mils for .040″ and above |
It should be stored at <= 23 ºC and below 50% humidity, and packages should be allowed to equilibrate to layup room conditions before opening.
The guide suggests curing at 185°C (365°F).
Maximum cutting speeds of 550 to 600 SFPM are suggested.
IS410 laminates are imaged using standard aqueous dry films and are compatible with cupric chloride and ammoniacal etchants.