The manual introduces the use of the ET-1002 digital multimeter, including safety information, operating rules, instrument structure, measurement operation, specification instructions, maintenance and warranty information, etc.
The Minipa ET-1002 is a digital multimeter with a 3 1/2-digit display for DC/AC voltage, DC current, resistance, transistor gain (hFE), diode, and continuity measurements. This instructions manual covers its safety information, operating rules, instrument structure, measurement procedures, specifications, maintenance, and warranty.
The manual states that the instrument complies with IEC 1010, pollution degree 1, overvoltage category CAT I 600 V, and double insulation, and warns not to measure voltages greater than 600 V DC/AC RMS. It also describes battery and fuse replacement and the six-month warranty registration process. This manual is written in Portuguese.
| Display | 3 1/2 digits |
|---|---|
| Low-battery indicator | Yes |
| Protective holster | Yes |
| DC voltage measurement | Yes |
| AC voltage measurement | Yes |
| Resistance measurement | Yes |
| DC current measurement | Yes |
| Continuity test | Yes |
| Diode test | Yes |
| Transistor hFE test | Yes |
| Safety standard | IEC 1010, pollution degree 1 |
| Overvoltage category | CAT I 600 V |
| Insulation | Double insulation |
| Maximum voltage | 600 V DC/AC RMS |
| AC voltage display | RMS for sine wave |
| Battery | 9 V |
Contact the dealer immediately.
Do not attempt to measure voltages greater than 600 V DC/AC RMS.
Remove the old battery, install a new 9 V battery, and replace the battery compartment cover and screw.
The warranty certificate is valid for six months from the purchase date.