WSDOT AASHTO T 329 Moisture Content of Asphalt Mixtures by Oven Method Test Procedure

This standard specifies the determination method of the moisture content of asphalt mixtures.


WSDOT AASHTO T 329 Moisture Content of Asphalt Mixtures by Oven Method Test Procedure - cover page
Brand
WSDOT
Category
Other
Document type
Other
Language
English
Pages
6
File format
PDF
File size
267 KB
Published
31 October, 2023
Updated
31 October, 2023
MD5 checksum
A011CEF80F67F9CE3D5C2A073C0FDD0C

About this manual

This document is the WSDOT Materials Manual procedure for the moisture content of asphalt mixtures by the oven method, prepared as a field operating procedure (FOP) for AASHTO T 329 (22). It lists the apparatus needed, the sample requirements, the numbered test steps, and the calculations used to decide when a sample has reached constant mass.

The procedure determines moisture content by comparing the wet mass of a sample with its mass after drying to constant mass. Included are worked calculation examples, a performance exam checklist with trial elements, and the reporting requirements: forms approved by the agency, the sample ID, and moisture content to the nearest 0.01 percent.

What's inside

  • Scope
  • Overview
  • Apparatus
  • Sample
  • Procedure
  • Calculations
  • Constant Mass
  • Performance Exam Checklist
  • Report

Specifications

Balance or scale capacity and readability2 kg capacity, readable to 0.1 g, conforming to AASHTO M 231
Oven temperature163 ±14°C (325 ±25°F)
Thermometer range50 to 200°C (122 to 392°F), readable to the nearest 2°C (4°F)
Minimum test sample size1000 g
Initial drying time90 ±5 minutes
Constant mass criterionMass change of no more than 0.05 percent
Reporting precisionMoisture content to the nearest 0.01 percent

Frequently asked questions

What oven temperature is used for the oven method?

The oven is preheated to the Job Mix Formula mixing temperature range; if that is not supplied, 163 ±14°C (325 ±25°F) is used.

What is the minimum size of the test sample?

The test sample must be a minimum of 1000 g, obtained per the FOP for AASHTO R 97 and reduced per the FOP for AASHTO R 47.

How long is the sample dried before constant mass is checked?

It is initially dried for 90 ±5 minutes, then dried at 30 ±5 minute intervals until the mass does not change by more than 0.05 percent.

How is moisture content calculated?

Moisture content is calculated as a percent using (Mi − Mf) / Mf × 100, where Mi is the initial moist mass and Mf the final dry mass.

Download PDF (267 KB)

More WSDOT Manuals


View all WSDOT manuals →