Kaiyangxing KYX-D001 Radar Sensor Application Manual

KYX-D001 radar application manual, introduces the product's features, quick test guide, interface protocol, data analysis examples and other content


Kaiyangxing KYX-D001 Radar Sensor Application Manual - cover page
Brand
开阳星
Category
radar
Document type
Programming Manual
Language
Chinese
Pages
10
File format
PDF
File size
503 KB
Published
30 October, 2023
Updated
30 October, 2023
MD5 checksum
BC45201B8CBF5EDC40A5DCF906A84AC4

About this manual

This is the V2.4 application manual for the KYX-D001 radar sensor from Shenzhen Kaiyangxing Information Technology, a millimeter-wave radar solution supplier. The sensor stays in sleep mode after power-up and is woken either by a serial wake command or by a rising edge on the GPIO pin; after each wake it takes one measurement of parking space occupancy and signal strength, sends the data over the serial port, and returns to sleep. The manual covers the product functions, a quick test procedure, the interface protocol and worked parsing examples.

The quick test section shows how to connect the sensor through a USB-to-serial module (3.3 V port with more than 100 mA drive capability), how to configure the serial assistant at 115200 baud, 8 data bits, 1 stop bit, no parity and no flow control, and how to send the wake command. The protocol section defines the RadarConfiguration, RadarFeedback and TargetStatus messages with their frame headers, command IDs, checksums and frame tails, followed by examples for calibration, parameter write, parameter read and target information parsing. Contact details for the company close the document. This manual is written in Chinese.

What's inside

  • 产品功能简介
  • 快速测试指南
  • 接口定义
  • 快速使用流程
  • 接口协议
  • 雷达配置 (RadarConfiguration)
  • 雷达配置响应 (RadarFeedback)
  • 目标状态 (TargetStatus)
  • 数据解析示例
  • 环境校准

Specifications

Serial port settings115200 baud, 8 data bits, 1 stop bit, parity and flow control NONE
Supply current requirement (via USB-to-serial 3.3 V port)Greater than 100 mA
Detection sensitivity range0x01–0x0F (default 0x0B)
GPIO multiplex mode default0x02 input mode, used for sleep wake-up
Distance calculationActual distance = byte3 * 0.05, unit: m
Environmental calibration time1.5 seconds
Wake-up commandAA AA D9 B2 68 2C 46 55
Interface pinsVCC, GND, GPIO, RXD, TXD

Frequently asked questions

How is the KYX-D001 radar sensor woken up?

It can be woken by a wake command received over the serial port, or by applying a rising edge level change on the GPIO pin.

What happens after the radar is woken?

It runs once, acquires the parking space occupancy status and signal strength, sends this over the serial port, and then automatically returns to sleep.

How long does the environmental calibration command take?

It takes 1.5 seconds and stores the environmental variables so that the effects of the radome and the complex on-site environment are reduced.

How is the target distance calculated?

The distance is the third byte of the target status message multiplied by 0.05, in meters.

Download PDF (503 KB)