C2000-A2-SDD4040-DD1 is a 485 type digital input and output module. DI can collect wet contact switch quantity signals and count the state of switch changes. DO is a C-type relay output, supporting both level and pulse output modes. This product adopts the standard Modbus RTU communication protocol, which is suitable for various industrial monitoring field applications. This product supports the C2000 device management and monitoring software, and can also be easily integrated with third-party SCADA software, PLC, and HMI devices.
The C2000-A2-SDD4040-DD1 is an RS485 digital input/output module from Konnad (Shenzhen United Innovation Automatic Control System Co., Ltd.). It has 4 digital inputs that acquire wet-contact switch signals and can count switch changes, and 4 digital outputs that are C-type relays supporting both level and pulse output modes. The module uses the standard Modbus RTU protocol and is intended for on-site industrial monitoring applications; it can be integrated with third-party SCADA software, PLCs and HMI devices and is supported by the C2000 device management and monitoring software. It mounts on a DIN rail or through locating holes, runs from 9 to 27 VDC, and is specified for -40 to 85 °C operation.
The manual describes the hardware, including technical parameters, product appearance, indicator lights, port assignments, dimensions and installation, and then explains software operation for creating a device and monitoring device status. A communication protocol chapter gives the register list and example Modbus frames for reading and writing DO states, reading DI states and positive pulse states, writing a single DI positive pulse count, and writing DO working modes. A packing list and a product service and warranty chapter close the document. This manual is written in Chinese.
| DI input type | Wet contact, level + pulse counting |
|---|---|
| DI sampling frequency | 1 kHz |
| DO output type | C-type relay |
| DO output modes | Level + pulse |
| Contact rating | 30 V / 3 A |
| Serial interface | RS485, 1 port |
| Communication protocol | Modbus RTU |
| Input voltage | 9~27 VDC |
| Current consumption | 80 mA @ 12 VDC |
| Dimensions | 75 x 105 x 30 mm |
| Installation | Locating holes / DIN rail |
| Operating temperature | -40 °C to 85 °C |
| Storage temperature | -60 °C to 125 °C |
| Relative humidity | 5% to 95% RH, non-condensing |
It uses the standard Modbus RTU protocol over an RS485 port, so it can be integrated with third-party SCADA software, PLCs and HMI devices.
The four DO channels are C-type relay outputs that support both level and pulse output modes, with a contact rating of 30 V / 3 A.
It accepts 9 to 27 VDC over the Phoenix terminals and draws about 80 mA at 12 VDC.
The warranty is 6 years for the version with a housing and 3 years for the version without a housing; accessories are not covered.