Ethertronics LORA-M-AX-01 (V1.2) Module Integration Guideline

This document provides hardware description about the Ethertronics LORA-M-AX-01 (V1.2) module and provides simple application examples. The module supports UART, SPI and I2C interfaces.


Ethertronics LORA-M-AX-01 (V1.2) Module Integration Guideline - cover page
Brand
Ethertronics
Category
Other Electronics
Document type
Other
Language
English
Pages
12
File format
PDF
File size
526 KB
Published
27 October, 2023
Updated
27 October, 2023
MD5 checksum
00F68801B08FD01679161B41115182D1

About this manual

This document provides a hardware description and integration guidelines for the Ethertronics LORA-M-AX-01 (V1.2) module. It details simple applications using the module with the Ethertronics Active Steering Antenna ETH-B2-01-ASA to maximize RF range. The module supports three different interfaces: UART, SPI, and I2C, with specific layout modifications required for each.

What's inside

  • General Description
  • Pin Diagram
  • Pin Description
  • Recommended Landing Pattern
  • Typical Application Schematics
  • PCB Design and general use guide line
  • RF Design Guide Line
  • Supply Guide Line
  • UART Guide Line

Specifications

Supply Voltage (VDD)2.5V to 3.6V
Current Consumption (Stop mode with RTC)1.8 mA
Current Consumption (Sleep Mode)3 mA
Current Consumption (Run Mode)9 mA
Current Consumption (TX Mode)100 mA
Current Consumption (RX Mode)20 mA
Maximum Consumption (TX)128 mA
UART Default Baud Rate115200

Frequently asked questions

Which interfaces does the Ethertronics LORA-M-AX-01 (V1.2) support?

The module can be used with three different interfaces: UART, SPI, and I2C.

What is the recommended antenna impedance for the module?

The RF pin is matched to 50 Ohms by default, and the antenna should also be matched to 50 Ohms.

What LDO current rating is recommended for stable supply?

It is advised to use a LDO delivering up to 2A to ensure good running of the module during high current peaks.

Download PDF (526 KB)