This document describes the NetApp HCI 1.4 deployment steps, including network configuration, IP address configuration, environmental requirements, etc.
NetApp HCI 1.4 is a converged infrastructure solution that combines storage and compute resources to build a VMware vSphere environment backed by NetApp Element software. This guide assists administrators in preparing the environment and completing the deployment using the NetApp Deployment Engine. It details the architecture, best practices for network and switch configuration, and post-deployment tasks.
| Supported Node Models | NetApp H300S, H300E, H500S, H500E, H700S, H700E and H410C |
|---|---|
| Storage Switch Speed Requirement | at least 10GbE per port (up to 25GbE per port is supported) |
| Management Switch Speed Requirement | at least 1GbE per port |
| Jumbo Frames Support | 9000 byte packets end-to-end |
| Network Latency Requirement | not exceed 2ms |
| Cable Category Requirement | Category 5e or Category 6 rated RJ45 cables |
NetApp HCI deployment requires three network segments: Management, VMware vMotion, and Storage.
All switch ports connected to NetApp HCI nodes must be configured as spanning tree edge ports.
The round-trip network latency between all storage and compute nodes should not exceed 2ms.