Dorner Servo Drive and Controller Installation, Operation, Maintenance, and Parts Manual

This document is a servo drive and controller installation, operation, maintenance, and parts manual for Dorner Mfg. Corp.


Dorner Servo Drive and Controller Installation, Operation, Maintenance, and Parts Manual - cover page
Brand
Dorner
Category
Automation control Equipment
Document type
Service Manual
Language
English
Pages
60
File format
PDF
File size
6.3 MB
Published
26 October, 2023
Updated
26 October, 2023
MD5 checksum
EDF839AB661433C856322E3E882EF641

About this manual

This manual (851-732 Rev. C) covers the Dorner servo drive and controller for 2200 and 3200 Series conveyors. It describes the stand-alone controller, conveyor components, controller power requirements, and gearmotor compatibility.

The document gives installation steps for 2200 Series bottom flush mount and 3200 Series side mount servo drives, wiring notes, a ten-step application setup operation section, preventive maintenance and adjustment, and service parts lists.

What's inside

  • Introduction
  • Warnings − General Safety
  • Product Description
  • Specifications
  • Installation
  • Wiring
  • Operation
  • Setting Up Your Application
  • Preventive Maintenance and Adjustment
  • Service Parts

Specifications

Input volts115 or 230 V
Input phase1
Continuous amps out3
Peak amps out9
Continuous watts1100

Frequently asked questions

What tools are required for installation?

The manual lists hex key wrenches (4 mm, 5 mm), wrenches (8 mm, 10 mm), a flat-blade screwdriver, and a torque wrench.

What should be done before wiring the controller?

Lock out power before wiring; hazardous voltage can cause severe injury or death.

What torque is specified for the M6 screws that secure the servo and mount assembly?

Tighten the two M6 screws to 60 in-lb (7 Nm).

How does the manual describe the stand-alone controller?

It is fully assembled and functional, and no internal wiring is necessary.

Download PDF (6.3 MB)