SILICONAIR2 is a low power, high performance surface integrated module on board targeted at ZigBee networking applications.
This user manual describes the SILICONAIR2, a Tigo module built on board around NXP's JN5148 wireless microcontroller for ZigBee networking applications. The document explains that the module integrates all required RF components and a PCB antenna, so products can be designed by adding the module circuit on board and connecting sensors and switches to the IO pins. It covers the 2.4GHz IEEE802.15.4 radio, the security coprocessor supporting 128-bit AES-CCM* modes, and the module feature list.
The manual then gives the specifications and DC/RF/peripheral characteristics at VDD=3.0V and +25°C, an I/O configuration drawing with a 41-pin assignment table, maximum ratings and operating conditions, the RF module PCB footprint dimensions, and the module label description including FCC ID, IC number, model and serial number format. A declaration page covers Industry Canada licence-exempt RSS compliance in English and French.
| Operating voltage | 2.7-3.6 V |
|---|---|
| Receiver sensitivity | -95 dBm |
| Maximum transmit power | +3.24 dBm |
| PCB antenna gain | +2 dBi |
| Sleep current (with active sleep timer) | 2.6 uA |
| Deep sleep current | 1.3 uA |
| Module dimensions | 18 x 30 x 3.5 mm |
| Ambient temperature range | -40 °C to 85 °C |
| Memory | 128 kB ROM, 128 kB RAM, 4 Mbit serial flash |
| ADC / DAC resolution | 12-bit, up to 100 ks/s |
It is a 2.4GHz module compatible with IEEE802.15.4 and ZigBee, and it can run Jennic's JenNet networking protocol or ZigBee PRO.
The module is specified for 2.7-3.6V operation in its feature list. The operating conditions table lists VDD from 2.3V minimum to 3.6V maximum.
Receiver sensitivity is -95dBm.
The label carries FCC ID XMYSILICONAIR2 and IC 11021A-SILICONAIR2, with MODEL: SILICONAIR2.
To avoid exceeding the IC radio frequency exposure limit, human proximity to the antenna should not be less than 20 cm.