ACOEM HAWK Wireless Vibration Gauge Portable Multichannel Instrument User Manual

This manual describes the use and operation procedure of hawk wireless vibration gauge


ACOEM HAWK Wireless Vibration Gauge Portable Multichannel Instrument User Manual - cover page
Brand
ACOEM
Category
Analyzer
Document type
User Manual
Language
English
Pages
71
File format
PDF
File size
2.8 MB
Published
26 October, 2023
Updated
26 October, 2023
MD5 checksum
9266008B00116D035AE3DA82B72A484F

About this manual

The ACOEM HAWK is a portable multichannel instrument with a large touchscreen, a 3-axis wireless sensor, and accessories for vibration analysis. The manual describes two versions: HAWK standard with red rubber for safe areas and HAWK-EX with black rubber for ATEX Zone II areas; all functions apply to both versions.

The HAWK user manual, document reference DOC3122 from December 2014 with firmware version 1.11, covers first power-up, user interface and connections, built-in and wireless sensors, data exchange with a PC, general settings, the Supervisor module with NEST software, the balancing module, and maintenance. It also includes safety instructions and an appendix on data storage organization.

What's inside

  • General presentation
  • Safety instructions
  • First power-up
  • User interface
  • Connections
  • Built-in sensors
  • Wireless Sensor
  • Supervisor module
  • Balancing module
  • Maintenance

Specifications

VersionHAWK standard (red rubber) for safe area; HAWK-EX (black rubber) for ATEX Zone II area
DisplayLarge touchscreen
Maximum input voltage (connectors A/B/C/D)±24 V DC, ±24 V AC peak
Connector protectionIP65
Charging timeAbout 6 hours when switched off
Firmware version1.11

Frequently asked questions

What versions of the HAWK are available?

The HAWK standard has red rubber for safe areas, and the HAWK-EX has black rubber for ATEX Zone II areas.

How long does charging take?

A full charge requires about 6 hours, and usual charging time is about 6 hours when the instrument is switched off.

What is the maximum input voltage for connectors A to D?

The maximum input voltage is ±24 V DC or ±24 V AC peak.

How is the WLS sensor firmware updated?

Copy the new .czip firmware file into the Update folder, then switch the sensor off and on; the red LED flashes during the update and the blue LED turns on when complete.

Download PDF (2.8 MB)