This manual describes the M105 Digital Surface Unit (w/Battery Level Tester), a device used for underwater communication. This manual includes information on the device's features and characteristics, how to use it, and how to maintain it.
The M105 Digital is a compact, ultrasonic, single side band transceiver designed for surface-to-diver and diver-to-surface underwater communications. It features a rechargeable battery, an integrated battery level tester, and a hand-held push-to-talk microphone. The unit is housed in a heavy-duty, water-resistant glass fiber reinforced nylon case.
| Transmitter output power | 1/2 watt |
|---|---|
| Modulation | Single Side band, suppressed carrier |
| Operating frequency | 32.768 kHz upper side band |
| Power | 6 volts lead rechargeable |
| Battery Life | 48 hours (receiving only) |
| External Power | 12 volt, DC @ minimum of 1 amp |
| Transducer type | Piezoelectric type |
| Microphone type | Hand-held, Push-to-talk, Dynamic, 500 ohm impedance |
| Receiver sensitivity | Greater than 110 dßv |
| Transmitter speech frequency bandwidth | 300 - 3300 Hz |
| Low Battery Alarm threshold | below 4.7 volts |
| Housing material | Glass fiber reinforced Nylon |
The battery life is 48 hours when receiving only.
A short tone burst sounds every 10 seconds when the battery level is below 4.7 volts.
You should recharge the unit when the red light on the battery level tester turns on.
The operating frequency is 32.768 kHz upper side band.