EO Hub and EO Genius V1.1 Installation Guide

About this manual

This guide provides detailed instructions for installing and connecting the EO Hub to EO Genius charging stations. It covers wiring connections for the serial bus, power, CT clamps, and Ethernet setup. It also explains how to configure the hub for communication with the eoCloud back office or a third-party OCPP server. The guide includes LED status indicators for troubleshooting and network security settings for firewall configurations.

What's inside

• Wiring Connections for the Genius Charging Stations and the Serial Bus
• Wiring Connections for the Hub
• Web Setup for the EO Hub
• Configuring the EO Hub to Communicate to a 3rd Party OCPP Back Office Server
• Further Technical Support

Frequently asked questions

What is the recommended Ethernet connection for the EO Hub?

An internet-enabled Ethernet connection using an RJ45 connector is required. The EO Hub IP address and DNS server address are assigned via DHCP, but it is best if the IP address is reserved in the DHCP table.

How do I configure the EO Hub to communicate with a third-party OCPP back office server?

Set up a host in eoCloud, assign the hub to the host, assign the charging stations to the hub, power up the hub and check that the charging station list is downloaded, load up the EO Hub web setup, switch the EO Hub into OCPP mode on the Global Settings, and update the OCPP connection setting in the OCPP Settings Page.