FastMig KMS 300, 400, 500 Operating manual, introduces the features and characteristics of the equipment, usage methods, etc
This manual provides instructions for operating, maintaining, and safely using the Kemppi FastMig KMS 300, 400, and 500 welding power sources. It covers setup, controls, welding procedures, maintenance, and troubleshooting. The manual includes technical specifications and safety warnings, with emphasis on proper placement, electrical connections, and service procedures.
Key sections include installation, control panel functions, MMA welding setup, service maintenance, and handling of electrical faults or overloads. Safety precautions are highlighted with "OBS!" warnings for user safety and equipment protection. This manual is written in Swedish.
| Voltage | 400 V 3~ |
|---|---|
| Fuses | 20 A for KMS 300, 25 A for KMS 400, 35 A for KMS 500 |
| Cable Cross-Section | 4 x 6.0 mm² |
The KMS 300 requires a 4 x 6.0 mm² cable with a 20 A fuse for proper operation.
The machine is intended for MMA and MIG/MAG welding using direct current.
The minimum cable diameter is 50 mm² for the KMS 300 and 70 mm² for the KMS 400 and 500.
The surface tilt must not exceed 15 degrees.