This document outlines how to set up the Envisalink4 for UNO standalone mode, as well as programming and installation.
This document outlines the procedures for setting up the Envisalink4 module in UNO standalone mode. It details how to activate the device on the EyezOn account, select the appropriate power supply, and physically connect the module and expansion units to the network and power source. The guide also explains how to verify the status of the LEDs to ensure successful installation and firmware download.
| Power Supply Voltage Range | 7.5Vdc to 16Vdc |
|---|---|
| Minimum Power Supply Current | 500mA |
| Maximum Zones (Fully Expanded) | 30 zones |
| MAC Address Format | 12 Digit ID starting with 001C |
You must allow up to 10 minutes for activation to complete and for the module to download the proper firmware.
Five solid green LEDs indicate that installation and activation were done correctly, with the LINK LED flashing occasionally to show network traffic.
A flashing KEYB LED after 10 minutes indicates that the module still has the default DSC firmware installed, suggesting a network problem.