Orcina OrcaFlexInterface FAST v8 User Manual

This document briefly describes how to use OrcaFlex coupled to FAST v8 for modeling floating offshore wind turbines.


Orcina OrcaFlexInterface FAST v8 User Manual - cover page
Brand
Orcina
Category
Other
Document type
User Manual
Language
English
Pages
5
File format
PDF
File size
239 KB
Published
18 October, 2023
Updated
18 October, 2023
MD5 checksum
9895A1C3B83C88DCDDFE207B486274C5

About this manual

This manual explains how to use the OrcaFlexInterface module in FAST v8 to simulate floating offshore wind turbines. It details the setup process, including required DLLs, time step alignment, and model configuration in OrcaFlex. The guide also covers output variables and steps to ensure proper load transfer between FAST and OrcaFlex.

The document assumes users have a valid OrcaFlex license and compatible FAST v8 version. It outlines how to configure the FAST input file, construct the OrcaFlex model, and apply initial loads to ensure equilibrium. Output variables from OrcaFlex are automatically added to FAST’s output file, and results can be accessed through OrcaFlex’s simulation file.

What's inside

  • Introduction
  • Modifying the FAST Input File
  • FAST Output Variables
  • Constructing the OrcaFlex Model
  • Setting Initial Conditions and Applied Loads

Specifications

Time StepMust match between FAST and OrcaFlex
DLL FileFASTlinkDLL.dll
Output Channels18 additional output channels

Frequently asked questions

What DLL is required to use OrcaFlexInterface with FAST?

A special DLL compiled by Orcina is required: FASTlinkDLL.dll.

How do I configure the FAST input file for OrcaFlexInterface?

Set CompHydro = 0, CompMooring = 4, and MooringFile = “”.

What are the output variables from OrcaFlexInterface?

18 additional output channels including forces and moments in six degrees of freedom.

Download PDF (239 KB)